|
High volume low head energy efficient axial flow pumps for high volume
waterfalls.
Propeller Type - Dewatering Pumps
FEATURES
 |
Axial flow, cast iron propeller provides for high efficiency,
high volume pumping at low
head. |
|
Highly efficient, continuous duty air filled, copper wound
motor with class E, insulation
minimizes the cost of operation. |
|
Built in thermal protection prevents motor failure due to
overloading, accidental run-dry and single phasing in three phase units. |
|
Double inside mechanical seals with silicon carbide faces,
running in an oil filled chamber and further protected by a lip seal running
against a replaceable, 430 stainless steel shaft sleeve, provides for the most
durable seal design available. |
|
Double shielded, permanently lubricated, high temperature C3
ball bearings rated for a B-10 life of 60,000 hours provide for extended
operational life. |
APPLICATIONS
|
Residential, commercial, industrial wastewater and site
drainage. |
|
Decorative waterfalls and fountains. |
|
Raw water supply from lakes or rivers. |
|
Tail Water Pump. |
| SPECIFICATIONS |
STANDARD |
OPTIONS |
| Discharge Size |
4"~6" N.P.T. (100~150 mm) |
|
| Horsepower Range |
½, 1, 2 Hp. (.4~1.5 kW) |
| Performance Range |
|
| Capacity |
100~644 G.P.M. (.4~2.44 m3 /min) |
| Head |
1.6~11 Ft. (.5~3.5 m) |
| Maximum water temperature |
104º F. (40º C.) |
| Materials of Construction |
|
| Casing |
Cast Iron/Stainless Steel |
| Impeller |
Cast Iron - ASTM A48 Class 35 |
| Shaft |
403 Stainless Steel |
| Motor Frame |
Steel Plate/304 Stainless Steel |
| Fasteners |
304 Stainless Steel |
| Mechanical Seal |
Silicon Carbide |
| Elastomers |
NBR (Nitril Buna Rubber) |
| Impeller Type |
Axial Flow, High Volume |
| Solids Handling Capability |
Strainer size |
| Bearings |
Pre-lubricated, Double Shielded |
| Motor Nomenclature |
|
| Type, Speed, Hz |
Air Filled, 3600 /1800 Rpm, 60 Hz. |
Nema 3R inverter available for 230 V.,1 Ph.
operation from 1~2 Hp. |
| Voltage, Phase |
115 V.,1 Phase( ½ Hp)208, 230 or 440 V., 3Phase (1&2 Hp.) |
| Insulation |
Class E |
|
| Accessories |
Submersible Power Cable 32' (10 m) |
| Operational Mode |
Manual |
Length as Required |
Call or email us to find a dealer near you.
|
