|
[Water Feature Pumps] [Portable Dewatering] [Wastewater] [Sewage] [Effluent]
(FRP)
Semi-Vortex - Waste Water Pumps
FEATURES
 | Semi-vortex, FRP (Fiberglass Reinforced Plastic), impeller passes solids
and stringy material without clogging and increases wear resistance when
pumpage contains abrasive particles. |
| Double inside mechanical seals with silicon carbide faces, running in an
oil filled chamber and further protected by a lip seal, provides for the most
durable seal design available. |
| Highly efficient, continuous duty, air filled, copper wound motor with
class E, insulation minimizes the cost of operation. |
| Built in thermal & amperage sensing, protector prevents motor failure due
to overloading, single phasing (in three phase units), or accidental run-dry
conditions. |
| Double shielded, permanently lubricated, high temperature C3 ball bearings
rated for a B-10 life of 60,000 hours, extend operational life. |
| Utilization of application appropriate FRP & stainless steel components
increases corrosion resistance in a wide variety of applications. |
APPLICATIONS
| Residential, commercial, industrial, effluent, wastewater and site
drainage. |
| Chemical spill containment. |
| Decorative waterfalls, fountains and fish ponds. |
| Raw water supply from rivers or lakes.
|
| SPECIFICATIONS |
STANDARD |
OPTIONS |
| Discharge Size |
2" - 3" N.P.T. (50 - 80mm) |
|
| Horsepower Range |
1/3 - 2 (.25 - 1.5kW) |
| Performance Range |
| Capacity |
14-179 G.P.M. (.055 - .34m3/min) |
| Head |
7 Ft. - 50 Ft. (2.1 - 11.6m) |
| Maximum water temperature |
140º F. (60º
C.) |
| Materials of Construction |
| Casing (upper)/(lower) |
FRP (ABS + G20) / ABS |
| Impeller |
FRP (PPO + G20) |
| Shaft |
403 Stainless Steel |
| Motor Frame |
304 Stainless Steel |
| Fasteners |
304 Stainless Steel |
| Mechanical Seal |
Silicon Carbide |
| Elastomers |
NBR (Nitril Buna Rubber) |
| Impeller Type |
Semi-Vortex, solids handling. |
| Solids Handling Capability |
1" (25 mm) |
| Bearings |
Pre-lubricated, Double Shielded |
| Motor Nomenclature |
| Type, Speed, Hz |
Air Filled, 3600 Rpm, 60 Hz. |
Nema 3R inverter
available for 230 V., 1 Ph. operation for 2 Hp. |
| Voltage, Phase |
115 or 230 V., 1 Ph., 230 or 460 V.3Ph. |
| Insulation |
Class E |
| Accessories |
Submersible Power Cable 32' (10 m) |
Length as Required |
| Operational Mode |
Manual |
Model A (Automatic), Model AW (Automatic
Alternating)
TOP (FRP) Slide rail system |
Call or email us to find a dealer near you.
|
