|
[Water Feature Pumps] [Portable Dewatering] [Wastewater] [Sewage] [Effluent]

(FRP) Semi-Vortex - Sewage & Waste Water Pumps

FEATURES
 | Semi-vortex, FRP (Fiberglass Reinforced Plastic), impeller passes solids
and stringy material without clogging and increases wear resistance when
pumpage contains abrasive particles. |
 | Double inside mechanical seals with silicon carbide faces, running in an
oil filled chamber and further protected by a lip seal, provides for the most
durable seal design available. |
 | Highly efficient, continuous duty, air filled, copper wound motor with
class E, insulation minimizes the cost of operation. |
 | Built in thermal & amperage sensing, protector prevents motor failure due
to overloading, single phasing (in three phase units), or accidental run-dry
conditions. |
 | Double shielded, permanently lubricated, high temperature C3 ball bearings
rated for a B-10 life of 60,000 hours, extends operational life. |
 | Utilization of application appropriate FRP & stainless steel components increases
corrosion resistance in a wide variety of applications. 
|
APPLICATIONS
| SPECIFICATIONS |
STANDARD |
OPTIONS |
| Discharge Size |
2~3'' N.P.T (50 ~ 80mm) |
|
| Horsepower Range |
1/5 ~ 2Hp. (.2 ~ 1.5 KW) |
| Performance Range |
| Capacity |
14 ~ 211 G.P.M. (.055 ~ .34 m3/min) |
| Head |
7 Ft. ~ 38 Ft. (2.1 ~ 11.6 m) |
| Maximum water temperature |
140º F. (60 C.) |
| Materials of Construction |
| Casing (upper)/(lower) |
FRP (ABS + G20) / ABS |
| Impeller |
FRP (PPO + G20) |
| Shaft |
403 Stainless Steel |
| Motor Frame |
304 Stainless Steel |
| Fasteners |
304 Stainless Steel |
| Mechanical Seal |
Silicon Carbide |
| Elastomers |
NBR (Nitril Buna Rubber) |
| Impeller Type |
Semi-Vortex, solids handling |
| Solids Handling Capability |
1 1/4" (35mm) |
| Bearings |
Pre-lubricated, Double Shielded |
| Motor Nomenclature |
| Type, Speed, Hz |
Air Filled, 3600 Rpm, 60 Hz. |
Nema 3R inverter available for 230 V.,1Ph.
operation for 2 Hp. |
| Voltage, Phase |
115 or 230 V., 1 Ph., 230 or 460 V. 3 Ph. |
| Insulation |
Class E |
|
| Accessories |
Submersible Power Cable 32' (10 m) |
Length as Required |
| Operational Mode |
Manual |
Model A (Automatic), Model AW (Automatic
Alternating)
TOK (FRP) Slide rail system |
Call or email us to find a dealer near you.
|